Programming your system correctly is an essential step to ensuring you recieve filtered water. This article is a concise version of the basic Programming Instructions found in your manual. For information on your extra customizing options, visit our Optional Settings article.
Set the Current Time
To set the current time, press the Select button until you see 'Set Time', with the clock flashing (pictured below). Press (or hold) the Up/Down arrows to set the current time in your area. Double check the AM/PM on the right side of the screen.
Set the Water Hardness
Press the Select button to advance to the 'Set Hardness' screen. The hardness of your incoming water depends on your geographical location, so there is not an 'average' or 'normal' number for this setting. To calculate your specific number, use our Hardness Worksheet. Then, use the Up/Down arrows here to set the correct value:
Set the Recharge Time
Press the Select button to advance to the 'Recharge Time' screen. Your softener's recharge schedule will fluctuate based on your household's water use. Recharge cycles last about two hours, and usually happen once a week or so, on average. Make sure to set your recharge time during a period when your household is likely not using water:
Set the Salt Level
Setting the salt level will vary depending on your model, please visit our Salt Level Programming article to complete the control board set up.
Comments
0 comments
Please sign in to leave a comment.