Do you want to get the most out of your water softener? Using water softener cleanser every 4 months will help your system to run at peak performance! This solution cleans the inside of your system of contaminants, iron, and scale buildup to maximize your softener’s efficiency.
Locate Your Serial Number
Find the Serial Number printed on the inside rim of the tank, under the salt lid hinges.
Click on your Model Below:
First seven digits of your serial number.
Where To Purchase:
EcoPure® Water Softener Cleanser purchase information and available retailers can be found here.
How To Use the Cleanser:
Your salt level should be between 2 and 5 on the brinewell (tubing with numbers 1-8 inside the tank.)
1. You'll want to confirm your softener is out of bypass (handle should be pulled out):
2. Go ahead and open the salt lid and find the brinewell - this is the numbered tube on the left side of the salt tank. Find the slotted opening at the top of the brinewell (pictured).
3. Now pour one bottle of Cleanser into the brinewell slots.
4. Next you'll Hold the ‘Recharge’ button until the motor kicks on, then let go. This will start a recharge cycle which usually lasts around 2 ½ hours.
5. After the recharge is completed, run a few cold water faucets for 5-10 minutes to rinse any remaining cleanser from the unit.
Please let us know if this article was helpful by voting below.
Where To Purchase:
EcoPure® Water Softener Cleanser purchase information and available retailers can be found here.
How To Use the Cleanser:
Your salt level should be between 2 and 5 on the brinewell (tubing with numbers 1-8 inside the tank.)
1. You'll want to confirm your softener is out of bypass (handle should be pulled out):
2. Go ahead and find the Brinewell inside your salt tank. It is the 4-inch diameter dark tube with a lid on top. This lid will either pop off or screw off counterclockwise:
3. Go ahead and pour one bottle of Cleanser down the Brine well tube and replace the lid.
4. Next, hold the ‘Recharge’ button until the motor kicks on, then let go. This will start a recharge cycle which usually lasts around 2 ½ hours.
5. After the recharge is completed, run a few cold water faucets for 5-10 minutes to rinse any remaining cleanser from the unit.
Please let us know if this article was helpful by voting below.